THE HERO OF YOUR ENERGY...

Our advice: UPS battery replacement must be performed by professionals!

Incorrect battery replacement or wiring errors can seriously damage the device and jeopardize safety.

General UPS Battery Replacement

UPS battery replacement; varies depending on the expected life of dry or gel batteries, the charge-discharge cycle, and ambient temperature. Over time, the power supply battery may lose performance and may reach the end of its life accordingly.

In battery groups used in UPS and DC systems, required measurements and backup time are evaluated to identify end-of-life products, and the UPS battery is replaced with a suitable model. If there is no problem with the system structure, the desired backup time is calculated and alternative products are recommended.

UPS battery replacement can be performed for all brands and models. After the replacement, all connections must be completed correctly. During this process, the device must be turned off and the power connection must be cut.

Brands and Capacities We Service: The brands we frequently replace include Ritar, Datasafe, Viotech ve Genesis akü, among others:
12V 7Ah, 12V 9Ah, 12V 12Ah, 12V 18Ah, 12V 26Ah, 12V 40Ah, 12V 65Ah, 12V 80Ah, 12V 100Ah
and battery replacement operations for all power supplies with these specifications are performed successfully.

Process Steps

UPS Battery Replacement Process

Battery replacement is usually performed safely by following the steps below. Each model may differ and requires expertise!

01

Safety Precautions

Unplug the UPS and cut all power sources. Isolating the circuit with zero risk is crucial when working with electricity.

02

Type and Model

Before removing the old batteries, analyze the type and model. This information is required to choose the correct replacement.

03

Access the Compartment

Open the panel or compartments on the back or bottom of the device to access the UPS battery bay.

04

Remove the Battery

Carefully remove the battery from its place. Use proper gloves and precautions to protect against electrostatic discharge.

05

Disconnect Connections

Disconnect the positive (+) and negative (-) terminals. Ensure that battery terminals never touch each other.

06

Install New Battery

Place the new batteries correctly, connect the terminals securely with proper polarity, and close the covers.

07

Testing

Turn on the UPS before powering the system and verify normal operation and successful battery engagement.

08

Charging Stage

Connect the device to the mains and ensure the new batteries are fully charged. Wait for the time specified by the manufacturer.

Knowledge Base

Frequently Asked Questions

What does a UPS battery do?

It is the heart of the system that immediately supplies power during a blackout. It is vital for 24/7 organizations to avoid data loss and hardware damage.

Can a battery be repaired?

In global standards, repairing a power supply battery is usually not possible or safe. Replace it with a new one with the correct voltage, current, and capacity to extend your UPS life.

What is the lifespan of a UPS?

Depending on the environment, it is usually between 5 and 8 years. With good periodic maintenance, some systems operate reliably for up to 20 years with battery replacements.

Can gel batteries be used?

Standard UPS systems use sealed maintenance-free lead-acid dry batteries. However, depending on system conditions, high temperature tolerance, or special discharge curves, gel batteries can be preferred.

Message on WhatsApp